Lenze EVS 9300 series - Page 503

Index
abc
14-11
L
EDSVS9332S EN 3.0
Switching on the motor side, 4-31
Synchronous motors, rotor position adjustment,
5-5
System bus (CAN), 4-54
- Baud rate, 4-54
- Communication medium, 4-54
- Communication times, 4-54
- Processing times, 4-54
- Telegram runtimes, 4-54
- Wiring instructions, 4-55
System bus (CAN-IN), 9-76
System bus (CAN-OUT), 9-77
System fault CCr, 9-223
System speed monitoring NMax, 9-231
T
Table of attributes, 9-301
Technical data, 3-1
- Dimensions, 3-9
- Electrical data, 3-4
- General data/operating conditions, 3-2
Telegram runtimes, system bus (CAN), 4-54
Temperature ranges, 3-2
- Reduce rated current, 3-2
Tightening torques, power terminals, 4-26
Tni current controller, 9-258
Tnn speed controller, 9-258
Torque control, 8-9
- Setpoint input, 8-9
- Speed limitation, 8-10
- with speed limitation, 9-141
Torque limitation, 9-139
Torque setpoint, 8-9
touch probe, 8-30
Touch-Probe, 8-27
TRIP, 8-8 , 9-219
TRIP-RESET, 9-95
TRIP-SET, 9-94
Troubleshooting, 10-1
- Fault analysis with the history buffer, 10-3
- fault messages, 10-6
Troubleshooting and fault elimination, 10-1
V
Vertical shaft, 8-24
Vibration resistance, 3-2 , 3-3
Vibrations, 4-11
Voltage drop, 4-26
Vpi current controller, 9-258
Vpn speed controller, 9-258
W
Warning, 9-219
Warranty, 1-3
Waste disposal, 2-2
Wiring instructions, system bus (CAN), 4-55
Z
Zero pulse, 8-25
Zero pulse at the setpoint, 8-26
Zero pulse evaluation, 8-26
Zero pulse synchronisation, 8-26