Lenze EVS 9300 series - Page 8

Contents
ii
L
EDSVS9332S-A EN 3.0
4 Installation 4-11..........................................................
4.1 Mechanical installation 4-11..........................................................
4.1.1 Important notes 4-11.......................................................
4.1.2 Standard assembly with fixing rails or fixing brackets 4-12...........................
4.1.3 Thermally separated mounting (push-through technique) 4-13.........................
4.1.4 Mounting in ”cold plate” technique 4-16.........................................
4.2 Electrical installation 4-19............................................................
4.2.1 Protection of persons 4-19...................................................
4.2.2 Controller protection 4-21...................................................
4.2.3 Motor protection 4-21......................................................
4.2.4 Mains types/conditions 4-22.................................................
4.2.5 Interaction with compensation equipment 4-22....................................
4.2.6 Cable specifications 4-22....................................................
4.2.7 Power connections 4-23....................................................
4.2.8 Motor temperature monitoring 4-32............................................
4.2.9 Connection of a braking unit 4-36..............................................
4.2.10 DC-bus operation 4-37.....................................................
4.2.11 Control connections 4-39....................................................
4.2.12 STATE-BUS (X5/ST) 4-46....................................................
4.2.13 Connection of feedback systems 4-47..........................................
4.2.14 Connection of the master frequency input (X9) / master frequency output (X10) 4-52.........
4.2.15 System bus connection (CAN) (X4) 4-54.........................................
4.2.16 Automation interface (X1) 4-56................................................
4.3 Wiring according to EMC (installation of a CE-typical drive system) 4-57..........................
Part C
5 Commissioning 5-1.......................................................
5.1 Initial switch-on 5-1...............................................................
5.1.1 Switch-on sequence 5-2...................................................
5.2 Input of the motor data 5-4..........................................................
5.2.1 Operation with synchronous motors made by other manufacturers 5-5..................
5.3 Controller enable 5-8..............................................................
5.4 Input of the direction of rotation 5-8...................................................
5.5 Quick stop 5-9...................................................................
5.6 Change of the internal control structure 5-9..............................................
5.7 Change of the terminal assignment 5-10.................................................
5.7.1 Freely assignable digital inputs 5-10............................................
5.7.2 Freely assignable digital outputs 5-12...........................................
5.7.3 Freely assignable analog inputs 5-12...........................................
5.7.4 Freely assignable monitor outputs 5-12.........................................