Lenze EVS 9300 series - Page 9

Contents
iii
L
EDSVS9332S-A EN 3.0
6 During operation 6-1......................................................
6.1 Status indications 6-1..............................................................
6.1.1 Display on the controller 6-1................................................
6.1.2 Display on the keypad 6-1..................................................
6.1.3 Display in Global Drive Control 6-2............................................
6.1.4 Actual value display via codes 6-3............................................
6.2 Information on operation 6-4.........................................................
6.2.1 Switching on the motor side 6-4..............................................
6.2.2 Controller protection by current derating 6-5.....................................
Part D1.1
7 Parameter setting 7-1....................................................
7.1 General information 7-1...........................................................
7.2 Parameter setting with the XT keypad 7-2...............................................
7.2.1 Keypad commissioning 7-2.................................................
7.2.2 Description of the display element 7-3.........................................
7.2.3 Description of the function keys 7-4...........................................
7.2.4 Changing and saving parameters 7-5..........................................
7.2.5 Parameter set loading 7-6..................................................
7.2.6 Parameter set transfer 7-7..................................................
7.2.7 Activation of password protection 7-9.........................................
7.2.8 Diagnostics 7-10..........................................................
7.2.9 Menu structure 7-11.......................................................
7.2.10 Technical data 7-12........................................................
8 Configuration 8-1.........................................................
8.1 Configuration with Global Drive Control 8-1..............................................
8.2 Basic configurations 8-2............................................................
8.2.1 Speed control C0005 = 1XXX (1000) 8-4........................................
8.2.2 Torque control with speed limita tion 4000 8-9....................................
8.2.3 Master frequency coupling 8-11...............................................
8.2.4 Speed synchronism 8-23....................................................
8.2.5 Phase synchronism 8-24....................................................
8.3 Operating modes 8-34..............................................................
8.3.1 Parameter setting 8-34.....................................................
8.3.2 Control 8-34.............................................................
8.4 Change of the terminal assignment 8-35.................................................
8.4.1 Freely assignable digital inputs 8-35............................................
8.4.2 Freely assignable digital outputs 8-37...........................................
8.4.3 Freely assignable analog inputs 8-37...........................................
8.4.4 Freely assignable monitor outputs 8-38.........................................