Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 48 –
Trunk 111
Static 113
Configure Trunk 113
Add Creates a trunk, along with the first port member 113
Show Shows the configured trunk identifiers 113
Add Member Specifies ports to group into static trunks 113
Show Member Shows the port members for the selected trunk 113
Configure General 113
Configure Configures trunk connection settings 113
Show Information Displays trunk connection settings 113
Dynamic 115
Configure Aggregator Configures administration key and timeout for specific LACP
groups
115
Configure Aggregation Port 115
Configure 115
General Allows ports to dynamically join trunks 115
Actor Configures parameters for link aggregation group members on the
local side
115
Partner Configures parameters for link aggregation group members on the
remote side
115
Show Information 121
Counters Displays statistics for LACP protocol messages 121
Internal Displays configuration settings and operational state for the local side
of a link aggregation
122
Neighbors Displays configuration settings and operational state for the remote
side of a link aggregation
124
Configure Trunk 115
Configure Configures connection settings 115
Show Displays port connection status 115
Show Member Shows the active members in a trunk 115
Statistics Shows Interface, Etherlike, and RMON port statistics 100
Chart Shows Interface, Etherlike, and RMON port statistics 100
Load Balance Sets the load-distribution method among ports in aggregated links 125
History Shows statistical history for specified interfaces 104
Green Ethernet Adjusts the power provided to ports based on the length of the cable
used to connect to other devices
127
Table 4: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
