LevelOne GEL-1061 - Page 54

Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
– 54 –
IP Filter 287
Add Sets IP addresses of clients allowed management access via the web,
SNMP, and Telnet
287
Show Shows the addresses to be allowed management access 287
Port Security Configures per port security, including status, response for security
breach, and maximum allowed MAC addresses
289
Port Authentication IEEE 802.1X 291
Configure Global Enables authentication and EAPOL pass-through 293
Configure Interface Sets authentication parameters for individual ports 294
Show Statistics Displays protocol statistics for the selected port 298
DoS Protection Protects against Denial-of-Service attacks 307
DHCP Snooping 299
Configure Global Enables DHCP snooping globally, MAC-address verification,
information option; and sets the information policy
302
Configure VLAN Enables DHCP snooping on a VLAN 303
Configure Interface Sets the trust mode for an interface 304
Show Information Displays the DHCP Snooping binding information 306
IP Source Guard Filters IP traffic based on static entries in the IP Source Guard table, or
dynamic entries in the DHCP Snooping table
308
General Enables IP source guard and selects filter type per port 308
Static Binding 311
Configure ACL Table 311
Add Adds static addresses to the source guard ACL binding table 311
Show Shows static addresses in the source guard ACL binding table 311
Configure MAC Table 311
Add Adds static addresses to the source guard MAC address binding table 311
Show Shows static addresses in the source guard MAC address binding table 311
Dynamic Binding Displays the source-guard binding table for a selected interface 313
Administration 315
Log 316
System 316
Configure Global Stores error messages in local memory 316
Show System Logs Shows logged error messages 316
Remote Configures the logging of messages to a remote logging process 318
SMTP Sends an SMTP client message to a participating server 319
Table 4: Switch Main Menu (Continued)
Menu Description Page