58
PARAMETERS
These parameters are displayed:
◆ Mode - Enables HTTPS service on the switch. (Default: Enabled)
◆ Automatic Redirect - Sets the HTTPS redirect mode operation. When enabled,
management access to the HTTP web interface for the switch are automatically
redirected to HTTPS. (Default: Disabled)
WEB INTERFACE
To configure HTTPS:
1. Click Configuration, HTTPS.
2. Enable HTTPS if required and set the Automatic Redirect mode.
3. Click Save.
Access Management Configuration
Use the Access Management Configuration page to create a list of up to 16 IP addresses or
IP address groups that are allowed management access to the switch through the web
interface, or SNMP, or Telnet.
The management interfaces are open to all IP addresses by default. Once you add an entry
to a filter list, access to that interface is restricted to the specified addresses. If anyone tries
to access a management interface on the switch from an invalid address, the switch will
reject the connection.
PATH
Configuration \ Security \ Switch \ Access Management
Figure 18: Access Management Configuration
To Next Page
Loading...
