LevelOne GEP-1070 - Page 61

61
v1
noAuth
NoPriv
private
default_
rw_group
default_
view
default_
view
Community string
only
v1
noAuth
NoPriv
user
defined
user
defined
user
defined
user
defined
Community string
only
v2c
noAuth
NoPriv
public
default_r
o_group
default_
view
none
Community string
only
v2c
noAuth
NoPriv
private
default_rw
_group
default_
view
default
_view
Community string
only
v2c
noAuth
NoPriv
user
defined
user
defined
user
defined
user
defined
Community string
only
v3
noAuth
NoPriv
user
defined
default_r
w_group
default
_view
default_vi
ew
A user name
match only
v3
Auth
NoPriv
user
defined
user
defined
user
defined
user
defined
Provides user
authentication via
MD5 or SHA
algorithms
v3
Auth Priv
user
defined
user
defined
user
defined
user
defined
Provides user
authentication via MD5
or SHA algorithms
and data privacy using
DES 56-bit encryption
Note: The predefined default groups and view can be deleted from the system. You can then
define customized groups and views for the SNMP clients that require access.
Configuring SNMP System and Trap Settings
Use the SNMP System Configuration page to configure basic settings and traps for SNMP.
To manage the switch through SNMP, you must first enable the protocol and configure the
basic access parameters. To issue trap messages, the trap function must also be enabled
and the destination host specified.
PATH
Configuration \ Security \ Switch \ SNMP \ System
Figure 19: SNMP System Configuration