LevelOne GEP-1070 - Page 74

74
RMON Alarm
Use the RMON Alarm page for configurations.
PATH
Configuration \ Security \ Switch \ RMON \ Alarm
Figure 27: RMON Alarm Configuration
PARAMETERS
These parameters are displayed:
◆ Delete – Check to delete the entry after the next save.
◆ ID – Indicates the index of the entry. The range is from 1 to 65,535.
◆ Interval – Indicates the interval in seconds for sampling and comparing the rising and
falling threshold. The range is from 1 to 2^31-1.
◆ Variable – Indicates the particular variable to be sampled, the possible variables are:
■ InOctets: The total number of octets received on the interface, including framing
characters.
■ InUcastPkts: The number of uni-cast packets delivered to a higher-layer protocol.
■ InNUcastPkts: The number of broad-cast and multi-cast packets delivered to a
higher-layer protocol.
■ InDiscards: The number of inbound packets that are discarded even the packets are
normal.
■ InErrors: The number of inbound packets that contained errors preventing them from
being deliverable to a higher-layer protocol.
■ InUnknownProtos: the number of the inbound packets that were discarded because
of the unknown or un-support protocol.
■ OutOctets: The number of octets transmitted out of the interface , including framing
characters.