Publication date: June, 2015
Revision A1
IP address and UDP port for the accounting server in
question.
Shows the state of the server. It takes one of the
following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP communication is up
and running, and the RADIUS module is ready to
accept accounting attempts.
Dead (X seconds left): Accounting attempts were
made to this server, but it did not reply within the
configured timeout. The server has temporarily been
disabled, but will get re-enabled when the dead-time
expires. The number of seconds left before this occurs
is displayed in parentheses. This state is only
reachable when more than one server is enabled.
radiusAccClientExtRoundTripTime
The time interval (measured in milliseconds) between
the most recent Response and the Request that
matched it from the RADIUS accounting server. The
granularity of this measurement is 100 ms. A value of
0 ms indicates that there hasn't been round-trip
communication with the server yet.
Buttons:
Auto-refresh –Check this box to enable an automatic refresh of the page at regular
intervals.
Refresh - Click to refresh the page immediately.
Clear - Clears the counters for the selected server. The "Pending Requests" counter will not
be cleared by this operation.
To Next Page
Loading...
