Action Editor
Z-Max Advanced Programming & Systems Design Guide rac00-sdg
Revision A:11/2005 Page 85
Step 33: Press once to position the cursor in the priority field
Any priority level from 1 to 16 can be selected (1 is the highest
priority). A priority of "De", for default, will use the default priority
that is set in the priority editor of the System Setup menu.
Step 34: Press until you get to the desired priority value
Step 35: Press Select/Save
The menu will be returned to the point where another item can be
added, edited, or deleted if desired.
Group - GRP
Any Group number can be assigned to an Action
Step 36: Press once to position the cursor in the Group field
Step 37: Press and until you get to the desired Group number
Step 38: Press once to position the cursor in the Group state field
Step 39: Press until you get to the desired group state (see above for the
types of states)
Step 40: Press once to position the cursor in the priority field
Any priority level from 1 to 16 can be selected (1 is the highest
priority). A priority of "De", for default, will use the default priority
that is set in the priority editor of the System Setup menu.
Step 41: Press until you get to the desired priority value
Step 42: Press Select/Save
The menu will be returned to the point where another item can be
added, edited, or deleted if desired.
Button - BTN:
A switch (either local or networked) can be controlled via this action item.
Step 43: Press once to position the cursor in the Button Source Number
field
ADDING NEW ITEM
GRP 0000 REL De
ADDING NEW ITEM
BTN:0000 000 REL
To Next Page
Loading...
