Page 86
Step 44: Press and until you get to the desired Button source number
or enter the number directly from the keypad.
A value of zero indicates a local input. A nonzero number indicates an
input on another networked cabinet
Step 45: Press once to position the cursor in the Button Number field
Step 46: Press until you get to the desired Button number or enter the
number directly from the keypad.
Step 47: Press Select/Save.
The menu will be returned to the point where another item can be
added, edited, or deleted if desired.
Photocell - PHO:
This action item is used to enable or disable a photo cell.
Step 48: Press once to position the cursor in the Photocell Number field
Step 49: Press and until you get to the desired Photocell number or
enter the number directly from the keypad.
Step 50: Press once to position the cursor in the Enable/Disable field
Step 51: Press and to toggle between ENABLE and DISABLE
Step 52: Press Select/Save.
The menu will be returned to the point where another item can be
added, edited, or deleted if desired.
Occupancy sensor - OCC:
This action item is used to enable or disable an occupancy sensor.
Step 53: Press once to position the cursor in the Occupancy Number field
Step 54: Press and until you get to the desired Occupancy number or
enter the number directly from the keypad.
Step 55: Press once to position the cursor in the Enable/Disable field
Step 56: Press and to toggle between ENABLE and DISABLE
Step 57: Press Select/Save.
The menu will be returned to the point where another item can be
added, edited, or deleted if desired.
Action - ACT:
An action item can call another action item. This menu allows you to set this up.
ADDING NEW ITEM
PHO 000 DISABLED
ADDING NEW ITEM
OCC 000 DISABLED
To Next Page
Loading...
