2-34 MFP Service Manual
7500-XXX
956.01
Service
system board
RIP card assembly processor
over temperature failure
The RIP card assembly has exceeded safe
operating temperature.
Go to “956.01 RIP card assembly processor over
temperature failure” on page 2-176.
956.02
Service
system board
RIP card assembly cooling
fan failure
The RIP card assembly cooling fan is not
functioning properly.
Go to “956.02 RIP card assembly cooling fan
failure” on page 2-176.
956.03
Service
system board
RIP card assembly FPGA
failure
The RIP card assembly has failed.
Go to “956.03 RIP card assembly FPGA failure”
on page 2-177.
980.00
Service tray 3
comm.
Tray 3/4 communication
failure
A communication error occurred between the printer
engine card assembly and the 2TM/TTM controller
card assembly.
TTM equipped machines, go to “980.00 2TM/TTM
controller card assembly communication
failure” on page 2-177.
2TM equipped machines, refer to the Options
Service Manual.
980.01
Service tray 5
comm.
Tray 5 HCF communication
failure
A communication error occurred between the printer
engine card assembly and the HCF controller card
assembly.
Refer to the Options Service Manual.
980.02
Service
finisher error
Printer engine card-finisher
communication failure
A communication error occurred between the printer
engine card assembly and the finisher.
Refer to the Options Service Manual.
980.03
Service
standard bin
comm.
Exit interface card assembly,
communication failure
A communication error occurred between the printer
engine card assembly and the exit interface card
assembly.
Go to “980.03 Exit interface card assembly
communication failure” on page 2-178.
980.04
Service
duplex comm.
Duplex controller card
assembly communication
failure
A communication error occurred between the printer
engine card assembly and the duplex controller card
assembly.
Go to “980.04 Duplex controller card assembly
communication failure” on page 2-178.
980.05
Service
Flicker comm.
Engine flicker communication
failure
A communication error has occurred in the printer
engine card assembly.
Go to “980.05 Engine flicker communication
failure” on page 2-179
.
981.00
Service
finisher error
Stacker bin failure The sensor (stacker bin level) is not turned on within
the specified period after the stacker bin starts
rising.
Refer to the Options Service Manual.
981.01
Service
finisher error
Stacker bin upper limit failure The stacker bin abnormally rises beyond the
specified upper limit position (stacker bin level).
Refer to the Options Service Manual.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
