Repair information 4-57
7500-XXX
MPF transport pinch roll assembly removal
1. Remove the MPF rear cover. Go to “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the two end screws securing the upper bracket (A) to the MPF feed unit assembly.
4. Remove the upper bracket (A).
5. Remove the one center screw securing the MPF transport pinch roll assembly (B) to the upper bracket (A).
6. Release the bosses securing the MPF transport pinch roll assembly (B) to the upper bracket.
7. Remove the MPF transport pinch roll assembly (B) by moving it in the direction of the arrow.
Note: Do not touch the plastic surface of the MPF pinch roll.
Note: Bushings and springs may become detached.
Note: Before reinstalling, ensure you do not touch the plastic roll surface.
Boss
Boss
B
A
Left
To Next Page
Loading...
