Repair information 4-67
7500-XXX
Vertical drive gear assembly removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the printer left door assembly. See “Printer left door assembly removal” on page 4-75.
4. Open the printer left lower door assembly.
5. Remove the three screws securing the vertical drive gear assembly (A).
6. Release the harness from the clamp on the vertical drive gear assembly (A).
7. Remove the vertical drive gear assembly (A).
Left
A
To Next Page
Loading...
