Lexmark X850E - Tray Lift One Way Clutch; Gear Assembly Removal

Repair information 4-35
7500-XXX
Tray lift one way clutch / gear assembly removal
1. Remove the media feed unit assembly. Go to“Media feed unit assembly 1 removal” on page 4-20 or
“Media feed unit assembly 2 removal” on page 4-23.
2. Remove the harness from the bracket (A).
3. Remove the three screws securing the bracket (A) to the media feed unit assembly.
4. Remove the bracket (A).
Note: The gears may become detached from the bracket (A).
5. Remove the tray lift one-way clutch (B).
Harness
Washer
Clamp
A
Rear
B