Repair information 4-113
7500-XXX
Dual drive motor assembly removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Open the printer left door assembly.
4. Remove the PC cartridge.
5. Remove the exit 1 drive belt. See “Exit 1 drive belt removal” on page 4-112.
6. Disconnect the two harness connectors from the dual drive motor assembly (A).
7. Remove the four screws securing the dual drive motor assembly (A) to the printer.
8. Remove the dual drive motor assembly (A).
Warning: Depress the spring loaded gear (C) while removing the dual drive motor assembly (A) to prevent
damage.
Warning: Before reinstalling, depress the spring loaded gear (C) while replacing the dual drive motor assembly
(A) to prevent damage.
A
C
Rear
Connector
Connector
To Next Page
Loading...
