Repair information 4-173
7500-XXX
Inverter solenoid assembly removal
1. Open the ADF left cover assembly.
2. Remove the ADF front cover assembly. See “ADF front cover assembly removal” on page 4-166.
3. Loosen the set screw securing the damper (A).
4. Remove the damper (A).
5. Disconnect the connector from the inverter solenoid assembly (B).
6. Remove the screw securing the inverter solenoid assembly (B).
7. Remove the inverter solenoid assembly (B).
8. Remove the plunger from the inverter lever (C).
Note: Before reinstalling the inverter solenoid assembly (B), ensure that the plunger is properly inserted into
the inverter solenoid assembly (B) and attached to the inverter lever (C).
A
Set
screw
B
Connector
C
Front
Plunger
To Next Page
Loading...
