4-112 MFP Service Manual
7500-XXX
Exit 1 drive belt removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-315.
4. Release the hook on the drive belt flange (A).
5. Remove the drive belt flange (A).
6. Remove the exit 1 drive belt (B) from the drive pulley - 25 tooth (C).
Note: The drive pulley -25 tooth (C) may become detached.
7. Remove the exit 1 drive belt (B) from the exit 1 media shift assembly (D).
Note: Press on the exit 1 drive belt (B) while slowly turning the motor (E) by hand.
C
Rear
B
D
Left side view
E
A
Hook
B
To Next Page
Loading...
