Lexmark X850E - 2000-Sheet Dual Input (TTM)-Tray 4 Front Cables Removal

Repair information 4-233
7500-XXX
2000-sheet dual input (TTM)–tray 4 front cables removal
1. Remove the tray 4 assembly. See “2000-sheet dual input (TTM)–tray 4 assembly removal” on
page 4-216.
2. Remove the tray 4 front cover. See “2000-sheet dual input (TTM)–tray 4 front cover removal” on
page 4-228.
3. Place the tray 4 assembly on its right side, as shown in the figure.
4. Remove the E-clip with a prying tool securing the front tray lift pulley (A) to the tray lift shaft assembly (B).
5. Remove the front tray lift pulley (A).
Note: The tray 4 front cables (C) become detached.
6. Remove the tray 4 front cables (C) from the tray lift shaft assembly (B).