4-54 MFP Service Manual
7500-XXX
MPF feed unit assembly removal
1. Remove the MPF rear cover. “MPF rear cover removal” on page 4-58.
2. Disconnect the connector.
3. Release the harness from the clamp.
4. Remove the two screws securing the MPF feed unit assembly (A).
5. Remove the MPF feed unit assembly (A).
Note: Before reinstalling, place the harness along the slot on the left of the MPF feed unit assembly (A) so it
does not pinch the harness between the feed unit.
A
Left
Clamp
To Next Page
Loading...
