Repair information 4-83
7500-XXX
Sensor (tray 2 feed-out) removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the printer left door assembly. See “Printer left door assembly removal” on page 4-75.
4. Open the printer left lower door assembly. See “Printer left lower door assembly removal” on
page 4-70.
5. Remove the two screws securing the tray 2 feed-out sensor guide (A).
6. Remove the tray 2 feed-out sensor guide (A) while pulling on its center most point.
7. Disconnect the connector from the sensor (tray 2 feed-out) (B).
8. Release the hook securing the sensor (tray 2 feed-out) (B).
9. Remove the sensor (tray 2 feed-out) (B).
A
Left
A
B
Hook
Connector
To Next Page
Loading...
