Repair information 4-105
7500-XXX
Exit 1 media shift assembly removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-15.
4. Open the printer left door assembly.
5. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-315.
6. Open the printer front door assembly. See “Printer front door assembly removal” on page 4-6.
7. Remove the printer front left cover. See “Printer front left cover removal” on page 4-3.
8. Remove the two screws securing the bracket (A).
9. Remove the bracket (A) by lifting it upward.
10. Remove the exit 1 drive belt. See “Exit 1 drive belt removal” on page 4-112.
11. Disconnect the two connectors from the exit 1 media shift assembly (B).
12. Remove the two screws securing the exit 1 media shift assembly (B) to the printer.
13. Remove the exit 1 media shift assembly (B) by lifting it upward and outward in the direction of the arrow.
Note: Disconnect the two connectors from the sensor (exit 1 media shift) and the sensor (exit 1 bin full).
14. Remove the two screws securing the exit 1 media shift assembly (B).
A
To Next Page
Loading...
