Repair information 4-125
7500-XXX
AC power input socket removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Remove the rear lower cover. See “Rear lower cover removal” on page 4-12.
4. Remove the three screws securing the bracket (A).
5. Disconnect the two connectors to the AC power input socket (B).
6. Remove the two screws securing the AC power input socket (B) to the bracket (A).
7. Remove the AC GFI breaker (B).
Warning: Before reinstalling, ensure all connectors are plugged into their proper location to prevent
damage.
Rear
A
B
To Next Page
Loading...
