4-110 MFP Service Manual
7500-XXX
Exit 1 media shift gear removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-15.
4. Open the printer left door assembly.
5. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-315.
6. Open the printer front door assembly.
7. Remove the printer front left cover. See “Printer front left cover removal” on page 4-3.
8. Remove the exit 1 media shift assembly. See “Exit 1 media shift assembly removal” on page 4-105.
9. Remove the exit 1 media shift motor. See “Media shift motor removal” on page 4-107.
10. Remove the 2 screws securing the bracket (A) to the exit 1 media shift assembly (B).
11. Remove the bracket (A) from the exit 1 media shift assembly (B).
12. Slide the shift assembly (C) in order to release the shift assembly boss from the exit 1 media shift gear (D).
13. Remove the exit 1 media shift gear (D) by lifting it upward.
A
B
Left
To Next Page
Loading...
