4-156 MFP Service Manual
7500-XXX
Scanner cooling fan removal
1. Remove the ADF unit assembly. See “ADF unit assembly removal” on page 4-159.
2. Remove the scanner left cover. See “Scanner left cover removal” on page 4-134.
3. Remove the scanner right cover. See “Scanner right cover removal” on page 4-135.
4. Remove the scanner top rear cover. See “Scanner top rear cover removal” on page 4-133.
5. Disconnect the connector from the scanner cooling fan (A).
6. Remove the harness from the clamp.
7. Lift the scanner cooling fan (A) upward in the direction of the arrow.
8. Remove the scanner cooling fan (A).
Note: Before reinstalling the scanner cooling fan (A), ensure that the label on the scanner cooling fan (A) is
facing toward the rear of the scanner unit assembly.
Connector
Rear
Clamp
A
To Next Page
Loading...
