4-40 MFP Service Manual
7500-XXX
Sensor (media out) removal
1. Remove the appropriate media feed unit assembly. See “Media feed unit assembly 1 removal” on
page 4-20 or “Media feed unit assembly 2 removal” on page 4-23.
2. Remove the media out actuator. See “Media out actuator removal” on page 4-38.
3. Disconnect the connector from the sensor (media out) (A).
4. Release the hooks securing the sensor (media out) (A) to the media feed unit.
5. Remove the sensor (media out) (A).
Front
Harness
A
Hooks
Lower view
Hook
To Next Page
Loading...
