4-232 MFP Service Manual
7500-XXX
10. Remove two E-clips with a prying tool securing the two small pulleys (F) on the rear of the frame assembly.
11. Remove two small guides (G) and two small pulleys (F).
12. Remove the tray 4 rear cables (D) from the bottom plate (H).
Note: Before re-installing:
— It is recommended that all four cables be replaced.
— Ensure tray 4 rear cables (D) are not twisted or kinked.
— Route the cables properly as shown in the figure.
— Replace the cables by setting the frame assembly on its side as shown in the figure.
To Next Page
Loading...
