Diagnostic information 2-227
7500-XXX
Skew
The printed image is not paralleled with both sides of the media.
Step Check Yes No
1 Check printer installation placement.
Check the installation surface for irregularities.
Check for missing printer foot.
Is the setup surface normal?
Go to step 2. Correct the
installation
placement.
2 Properly load media into the media tray assembly.
Properly install the media tray assembly into the printer.
Re-print the defective image.
Does the error continue?
Go to step 3. Problem solved.
3 Is the media transfer route and the media route free of
contamination or debris?
Go to step 4. Remove debris
or
contamination.
4 Check the drive rolls on the media transfer route.
Check all rolls on the transfer route for contamination,
wear or damage.
Check whether the pinch rolls rotate freely and spring
pressure is applied evenly.
Are all drive rolls free of contamination, wear or
damage?
Go to step 5. Replace
defective rolls.
(Go to
applicable repair
procedures for
replacement.)
5 Check the printer engine card assembly.
Replace the printer engine card assembly
Perform a print test.
Does the error continue?
Problem solved. Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-128.
Leading edge
Trailing edge
To Next Page
Loading...
