D9U001ES2-0101_05108
18 Mattress
Sprint 200 stretcher is designed for special passive mattresses from LINET portfolio.
The manufacturer recommends the use of the following mattresses on the Sprint 200 stretcher:
Sprint 200 PASSIVE MATTRESSES
■ Sprint 200 Standard
■ Sprint 200 Comfort
■ Sprint 200 Advanced
Sprint 200 REACTIVE MATTRESSES
■ Sprint 200 Reactive
These mattresses removed from the Sprint 200 mattress support platform are not designed for patient transport.
18.1 Anti-slip coating
CAUTION!
Incompatibility with stretcher due to incorrect mattress dimensions!
► In the case of other mattresses check maximum approved mattress dimensions (Technical Specication
chapter) and its specic shape.
CAUTION!
This anti-slip coating is not intended to prevent mattress movement when subjected to large forces so care
must be taken during patient ingress & egress or with agitated patients.
CAUTION!
Placing any loose material such as sheets between the Sprint 200 mattress support platform and the bottom
surface of the mattress will reduce the eect of the anti-slip coating and extra care must be taken during pati-
ent ingress & egress or with agitated patients.
The bottom surface of the Sprint 200 mattress has an ‘anti-slip’ coating. This is intended to help prevent the mattress moving
around on the Sprint 200 mattress support platform during patient transport, mattress support platform articulation or whilst the
patient is moving around.
To Next Page
Loading...
Need help?
General
