EasyManuals Logo

LINET Sprint 200 User Manual

LINET Sprint 200
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
D9U001ES2-0101_0544
10.4 Transport
For a safe transport, observe the following:
Ensure that no cables are run over when moving a stretcher.
Ensure that the castors are not braked before moving the stretcher.
Adjust stretcher height to at least 20 cm below maximum height.
Push stretcher by handles on Head End or Foot End.
Move the stretcher exclusively on suitable oor surfaces.
Ensure the stretcher is braked when it should not move (see „14.2 Castor Control“ on the page 59).
For longer distances, ensure that the castor steering function is activated.
Ensure that the brakes are released before moving the stretcher.
Suitable surfaces:
Tile
Hard linoleum
Poured ooring
Unsuitable surfaces:
Too soft, unsealed or defective ooring
Soft wooden ooring
Soft and porous stone oors
Carpeted oors with underlay
Soft linoleum
Outdoor transport (especially from heliport) is allowed under these conditions:
Surface of an outdoor environment is not too soft and too segmented and too coarse but hard and at as required for indoor use.
10.4.1 Transport Position
Transport Position of the Sprint 200 stretcher:
► siderails up and locked
► height of the mattress support platform in accordance with ergonomically suitable drive
► not tilted mattress support platform
► parts of the mattress support platform adjusted according to the patient‘s state and needs
► Power Supply Cord disconnected from the mains power and correctly wound around the Accessory Rail at head end of the
Sprint 200 with scales or with i-Drive Power
► handles intended for transport (Foldable Handles or Fixed Handles or IV&Drive Infusion Stands/Pushing Handles) raised in
working position
WARNING!
Hospital staff is responsible for assessing the suitable adjustment of the mattress support platform in accor-
dance with patient‘s state and needs!
WARNING!
Placement of the accessories and of the compatible medical devices must not cause any hazard for patient or
for hospital staff or for the other persons and any damage to the product or to the surroundings during trans-
port of the Sprint 200 stretcher!
WARNING!
Siderails in down position can cause patient‘s fall from the Sprint 200 stretcher during transport of the Sprint
200 stretcher!

Table of Contents

Other manuals for LINET Sprint 200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LINET Sprint 200 and is the answer not in the manual?

LINET Sprint 200 Specifications

General IconGeneral
BrandLINET
ModelSprint 200
CategoryMedical Equipment
LanguageEnglish

Related product manuals