D9U001ES2-0101_05
77
Status of the Taring Signalisation
1) First step of the Taring:
processing after the pre-
ss and hold of the ZERO/T
Button.
2) Second step of the Taring:
instruction to press ZERO/T
Button again.
3) Third step of the Taring:
“0” is shown on the display.
15.3 Taring
Taring can be done in a range of 6,4kg to 319,5kg. Taring is used to set “0” on the display before placing the patient on the stret-
cher.
Taring must be done with an unloaded stretcher with mattress, bed sheets, pillows and necessary accessories, without the patient.
It is recommended to position mattress support platform about 20 cm above the lowest horizontal position.
To zero scales:
► Ensure that nothing and nobody touches the stretcher except you.
► Press and hold ZERO/T Button until IN PROGRESS... appears on the display and weight value starts to ash.
► Release ZERO/T Button.
PRESS ZERO appears on the display.
► Press ZERO/T Button again.
► Wait until a beep indicates stabilized scales during Taring.
“0” is shown on the display.
Place the patient on the stretcher.
To cancel Taring:
► Press WEIGHT/CLEAR Button while Taring.
To Next Page
Loading...
Need help?
General
