D9U001ES2-0101_0548
11.2 Indication of the stretcher connected to the mains (only Sprint 200
with scales)
Indicator Meaning
Sprint 200 with scales is connected to the mains.
Sprint 200 with scales is disconnected from the mains.
Connection to the mains power is visually indicated on the display of Scales and Bed Exit Alarm Control Panel.
To connect Sprint 200 with scales or with i-Drive Power to the mains power:
► Unwind the whole Power Supply Cord from the Accessory Rail at head end of the Sprint 200 with scales or with i-Drive
Power.
► Connect the attachment plug of the Power Supply Cord to the mains power.
To place Power Supply Cord to safety position (when Bed Exit Alarm Monitoring is not required):
► Wind the Power Supply Cord loosely around the Accessory Rail at head end of the Sprint 200 with scales or with i-Drive
Power as on the picture above.
To disconnect Power Supply Cord from the Sprint 200 with scales or with i-Drive Power:
► Disconnect the Power Supply Cord from the mains.
To Next Page
Loading...
Need help?
General
