Lucent Technologies DDM-2000 OC-3 User Manual

SET-SECU SET-SECU
11-430 Issue 3 June 2001 DDM-2000 OC-3
Execution of this command for security reasons affects all subsequent attempts to
establish login sessions but does not affect the currently active sessions.
When security is enabled, the following four types of users are permitted to access the
system with a valid login and password:
■ ? (help)
■ logout (logout)
■ rlgn (remote login)
■ set-passwd (set password)
■ set-link (set link)
■ ^T (toggle)
■ All rtrv commands except rtrv-lgn and rtrv-passwd
In addition to set-secu, the commands init-sys, rtrv-lgn, set-fecom,
set-feat, set-lgn, set-sync, rtrv-passwd, and rstr-passwd are restricted to
privileged users only. The following commands also become restricted to privileged
users only when security is enabled on a system:
■ cpy-prog (copy program)
■ ent-ulsdcc (enter upper layer section DCC)
■ init-pm (initialize performance-monitoring)
■ ins-prog (install program)
privileged The privileged user may execute any commands, including
restricted commands.
general The general user may execute any commands not restricted to
privileged users.
maintenance The maintenance user may only execute commands that access
the system, extract reports, and execute maintenance functions
through a specific set of commands. This user may not execute
any privileged commands.
reports-only The reports-only user may only execute commands that extract
reports from the system and several other basic commands.
When security is enabled on a system, only the following
commands may be executed by reports-only users:
Page 4 of 7

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English