SET-SECU SET-SECU
DDM-2000 OC-3 Issue 3 June 2001 11-433
Only one CIT port (CIT-1 or CIT-2) can be provisioned to run TL1. If one CIT port is
provisioned for TL1 and the user tries to set the other CIT ports to TL1 as well, the
following denial message will be displayed:
If an address of cit-all is entered, the user will be prompted for security and
timeout parameters only. If the CIT-1 or CIT-2 port is already provisioned to run TL1
(porttype=tl1), then the CIT-1 or CIT-1 security value cannot be changed to
disabled.
If a user enters a command and does not have valid permissions for that command, the
following denial message will be displayed:
RELATED COMMANDS
rtrv-lgn
rtrv-secu
set-fecom
set-lgn
SNVS
/* Status, Not in Valid State */
/* Only one CIT port can support TL1 at a time. */
PICC
/* Privilege, Illegal Command Code */
/* You are not authorized to execute this command. */
Page 7 of 7
To Next Page
Loading...
Need help?
General
