Lucent Technologies DDM-2000 OC-3 - Page 1345

363-206-285 Operation and Maintenance: IXL-001
Issue 3, June 2001 Page 17 of 18
DDM-2000 OC-3 MULTIPLEXER
CPro-2000 Graphical User Interface
and Provisioning Tool
The CPro-2000 Graphical User Interface and Provisioning Tool is a Microsoft
*
Windows
*
based user interface that can optionally be used with the DDM-2000 OC-3
Multiplexer. The tool simplifies and mechanizes administration, maintenance, and
provisioning operations for ring networks. With the tool a user can:
• Display and control cross-connections at each network element (NE) in a
subnetwork, and the entire subnetwork, including dual ring interworking (DRI)
(for example, drop and continue paths at DRI nodes).
• Obtain and display graphical images of the subnetwork configuration,
equipment, and cross-connections.
• Perform an analysis of the subnetwork to detect provisioning errors.
• Retrieve and store data about a selected NE.
• Backup and restore provisioning information including cross-connections, DS1
port options, DS3 port options, EC-1 port options, and OC-3 line options.
In response to a user, the tool automatically complies and sends all the necessary
commands to perform a task. If the user is provisioning cross-connections, for
example, the tool automatically prevents provisioning errors by comparing the new
provisioning information with the subnetwork inventory. For more information, see
190-523-1xx (release dependent), CPro-2000 User Manual .
* Registered trademark of Microsoft Corporation.