Lucent Technologies DDM-2000 OC-3 User Manual

IXL-001: Acceptance 363-206-285
Page1of2 Issue3,June2001
DDM-2000 OC-3 MULTIPLEXER
Acceptance Task Index
FIND YOUR JOB IN THE LIST BELOW. . . . . . . . . . THEN GO TO
Acceptance Procedures (Shelf Equipped)
NOTE:
The following procedures are for use in testing the DDM-2000 OC-3 Multiplexer
system after another organization has equipped it. The procedures test the
DDM-2000 OC-3 system after all circuit packs have been installed and the shelf
is looped back or after a system has been established end-to-end. They are not
intended to be used for initial system turnup or in establishing an end-to-end
system. System Turnup procedures are found in this manual under the System
Turnup/Circuit Order tab.
Test (Accept) DDM-2000 OC-3 Multiplexer (Equipped) —
Overview......................................... Acceptance: NTP-002
Test (Accept) DDM-2000 OC-3 Multiplexer shelf
(Looped Back) . . ................................... Acceptance: NTP-003
Test (Accept) End-to-End DDM-2000 OC-3
System(Network) .................................. Acceptance: NTP-004
Acceptance Procedures (Shelf Unequipped)
NOTE:
Procedures for installing and testing DDM-2000 OC-3 system bays, shelves,
and cables are found in 363-206-204, DDM-2000 OC-3 Multiplexer Installation
Manual .
Acceptance: NTP-002
Acceptance: NTP-003
Acceptance: NTP-004

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English