Lucent Technologies DDM-2000 OC-3 - Page 1364

IXL-001: System Turnup/Circuit Order 363-206-285
Page 4 of 44 Issue 3, June 2001
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
Service —Establish Initial T1
Establish Initial T1 Service —
(Group Equipped But Not In Service) . . . ..............SystemTurnup: NTP-033
Service — Establish Initial OC-3c (STS-3c)
EstablishDDM-2000OC-3c(STS-3c)Service ..........SystemTurnup: NTP-002
Circuit Order/Work Order Procedures
NOTE:
Some of these procedures are used to add, convert, or discontinue DS1
and/or DS3 service after the system is running with initial service. Other
procedures are used to add new shelves and optical spans and upgrade
system configurations.
Shelf/Span — Adding New
Add DDM-2000 OC-3 Node (Shelf) —
To Path Switched Ring
ShelfAddedinMiddleofOpticalSpan ................. CircuitOrder: NTP-026
Add DDM-2000 OC-3 Optical Span —
Span Added as Extension to
DDM-2000 OC-3 Ring . ............................. CircuitOrder: NTP-015
Add DDM-2000 OC-3 Shelf and Optical Span —
ShelfAddedasExtensiontoDDM-2000OC-12.......... CircuitOrder: NTP-018
Add OC-3 Optical Span Linear Extension —
Extension Added Between FT-2000
and DDM-2000 OC-3 or OC-12 Ring................... CircuitOrder: NTP-049
Shelf/Span — Discontinue
Span—OC-3Optical—Discontinue.................. CircuitOrder: NTP-019
Discontinue DDM-2000 OC-3 or OC-12 Node (Shelf) —
FromDDM-2000OC-3orOC-12PathSwitchedRing ..... CircuitOrder: NTP-027
NTP-033
SystemTurnup: NTP-002
NTP-026
NTP-015
NTP-018
NTP-049
NTP-019
NTP-027