363-206-285 Circuit Order: NTP-024
Issue 2, February 2000 Page 6 of 24
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
21.
NOTE:
If Kbyte/Sbyte (sync messaging) is enabled for the OC-3
MAIN 1 and MAIN 2(P) optical interfaces at any node in the
OC-3 ring, it must be enabled at all nodes in the OC-3 ring
and in the FUNCTION UNITS slots of the host OC-12 shelf.
NOTE:
The rtrv-oc3: command retrieves the
OC-3 Line Provisioning Report. This report displays
the provisioned configuration of OC-3 lines. See the
Commands and Reports section of 363-206-295,
DDM-2000
OC-12 Multiplexer, TARP Release 7, User/Service Manual—
Volume I
, and 363-206-285,
DDM-2000 OC-3 Multiplexer,
TARP Release 13 and Later, User/Service Manual—Volume
I
, for a description of the rtrv-oc3: command format.
Use the rtrv-oc3: command to obtain the
OC-3 Line Provisioning Report and verify if Kbyte/Sbyte
is enabled or disabled. Use the set-oc3: command to enable or
disable the Kbyte/Sbyte parameter, as required.
To Next Page
Loading...
Need help?
General
