NTP-026: Circuit Order 363-206-285
Page 10 of 10 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
22.
NOTE:
Shelves that are part of a subnetwork being partitioned into
multiple areas require that the NSAPAREA field and level 2
IS-IS routing parameters of the ent-ulsdcc-l3:
command be set. See Section 11 Commands and Reports
in 363-206-285,
DDM-2000 OC-3 Multiplexer, TARP Release
13 and Later, User/Service Manual —Volume I
, for an
explanation of the command parameters and 824-102-144,
Lucent Technologies 2000 Product Family, Operations
Interworking Guide For TARP Releases
, for an explanation
of the engineering rules for subnetwork partitioning.
Use the ent-ulsdcc-l3: command to designate the
NSAPAREA field and level 2 IS-IS routing, as required.
DLP-51523. Perform end-to-end OC-3 or OC-12 optical line test on optical
spans being established.
24.
NOTE:
Proper cross-connections must be made at each shelf to
establish the complete end-to-end path for the
DS1/DS3/EC-1 port being tested. After one path (ring1 or
ring2) has been tested, use the sw-path-( ): command
at both ends to test the other ring path.
Perform appropriate end-to-end transmission test for the circuits
being added, as required.
DLP-510A. Single Ring DS1 test
DLP-554B. Dual Ring Interworking (DRI) DS1 test
DLP-511C. Single Ring DS3 test
DLP-553D. Dual Ring Interworking (DRI) DS3 test
25. The system is now ready for initial service to be established.
Initial DS1 Service [System Turnup: NTP-004]
Initial DS3 Service [System Turnup: NTP-005]
Initial EC-1 Service [System Turnup: NTP-034]
Initial HDSL Service [System Turnup: NTP-003]
Initial LAN Service [System Turnup: NTP-028]
Initial T1 Service [System Turnup: NTP-033]
DLP-515
DLP-510
DLP-554
DLP-511
DLP-553
NTP-005
NTP-034
NTP-028
NTP-033
To Next Page
Loading...
Need help?
General
