Name: Lucent Technologies DDM-2000 OC-3
Brand: Lucent Technologies
Rating: 5 (1 reviews)

To Next Page

To Previous Page

363-206-285 Circuit Order: NTP-039

Issue 2, February 2000 Page 31 of 32

DDM-2000 OC-3 MULTIPLEXER

DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO

54. Reinstall all TGS/TG3 circuit packs in TIMING slot 1,ifstill

removed.

55.

NOTE:

If Kbyte or Sbyte (sync messaging) is enabled for the

main-1 and main-2 optical interfaces at any node in a ring,

it must be enabled at all nodes of the ring.

NOTE:

The rtrv-oc3: command retrieves the

OC-3 Line Provisioning Report. This report displays

the provisioned configuration of OC-3 lines. See the

Commands and Reports section of this manual for a

description of the rtrv-oc3: command format.

Use the rtrv-oc3: command to obtain the

OC-3 Line Provisioning Report and verify if Kbyte/Sbyte

is enabled or disabled. Use the set-oc3: command to enable or

disable the Kbyte/Sbyte parameter, as required.

Other manuals for Lucent Technologies DDM-2000 OC-3

Questions and Answers:

Need help?

Do you have a question about the Lucent Technologies DDM-2000 OC-3 and is the answer not in the manual?

General