Name: Lucent Technologies DDM-2000 OC-3
Brand: Lucent Technologies
Rating: 5 (1 reviews)

To Next Page

To Previous Page

NTP-039: Circuit Order 363-206-285

Page 32 of 32 Issue 2, February 2000

DDM-2000 OC-3 MULTIPLEXER

DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO

56.

NOTE:

If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must

also be enabled.

NOTE:

If Sync Autoreconfiguration is enabled at any line-timed node

in a ring, it must be enabled at all line-timed nodes of a ring.

NOTE:

The rtrv-sync: command retrieves the

Synchronization Report. This report displays the

provisioning and operational information on the

synchronization attributes of the DDM-2000. See the

Commands and Reports section of this manual for a

description of the rtrv-sync: command format.

Use the rtrv-sync: command to obtain the

Synchronization Report and verify if Sync

Autoreconfiguration is enabled or disabled. Use the set-sync:

command to enable or disable the Sync Autoreconfiguration

parameter, as required.

57. The ring configuration is now complete and new nodes may be

added as required [NTP-026].

Other manuals for Lucent Technologies DDM-2000 OC-3

Questions and Answers:

Need help?

Do you have a question about the Lucent Technologies DDM-2000 OC-3 and is the answer not in the manual?

General