Lucent Technologies DDM-2000 OC-3 User Manual

363-206-285 System Turnup: NTP-059
Issue3,June2001 Page2of12
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
2. Verify that the host WaveStar TDM 2.5G shelf is equipped with
Release 2.0 or later software. If not equipped with Release 2.0 or
later software, upgrade the WaveStar TDM 2.5G host shelf with
proper software. Verify that the DDM-2000 OC-3 shelves are
equipped with TARP Release 15 ring software.
3. Determine the optical loss of each optical span from office
records or by making the required measurements.
4. At WaveStar TDM 2.5G, verify/provision the WaveStar TDM 2.5G
low speed OC-3/OC-12 slots to “1+1", enable DCC channels, and
install circuit packs. (See Create New Optical Port Protection
Group, T 302 procedure in 365-371-102, WaveStar TDM 2.5G,
User/Service Manual) .
5. Use the rtrv-oc3/set-oc3 or rtrv-oc12/set-oc12
command at the remote DDM-2000 OC-3 shelf to verify/set
application (dcc) parameter for the OC-3/OC-12 MAIN slots
being used for this OC-3/OC-12 linear extension. For example,
set-oc3:main,dcc=identical or
set-oc12:main,dcc=identical

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English