363-206-285 Detailed Level Procedure: DLP-512
Issue 2, February 2000 Page 3 of 10
DDM-2000 OC-3 MULTIPLEXER
set-pmthres-vt1 Sets the thresholds of the VT1.5 path performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-secu Sets security on each CIT port and DCC interface.
Enabling security requires users to enter login and
password to access the system.
set-sync Sets synchronization mode switching to revertive or
nonrevertive. After the end-to-end system is
established, sets synchronization source to select the
line from which shelf loop-timing and/or the DS1 sync
output will be derived. Sets output mode to select the
source of the DS1 sync output.
Other optional features are set from the CIT but are not lost if the SYSCTL is
replaced.
!
CAUTION:
Execution of these commands may be service affecting.
These features may be found under the following listings:
ent-crs-sts1 Specifies STS-1 cross-connect routing. Used in
establishing service and/or performing transmission
tests.
ent-crs-sts3c Specifies STS-3c cross-connect routing. Used in
establishing service and/or performing transmission
tests.
ent-crs-vt1 Specifies VT1.5 (DS1) cross-connect routing. Used in
establishing service and/or performing transmission
tests.
set-ec1 SetsthecharacteristicsofanEC-1port.
set-feat Enables feature options that are licensed for use:
sts3c, vtpm, ds1pm.
set-oc1 Sets the characteristics of a OC-1 line. Sets the signal
degrade threshold of the OC-1 line as a bit error rate
(BER).
To Next Page
Loading...
Need help?
General
