DLP-512: Detailed Level Procedure 363-206-285
Page 4 of 10 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
set-oc3 Sets the characteristics of an OC-3 line pair. Sets the
signal degrade threshold of the OC-3 line as a bit error
rate (BER). Specifies if sync message signaling uses
kbyte or sbyte or is enabled or disabled. Specifies if
the concatenation mode (concat) of the OC-3 line is to
be independent STS-1 channels or an sts-3c channel.
set-oc12 Sets the characteristics of an OC-12 line pair. Sets the
signal degrade threshold of the OC-12 line as a bit
error rate (BER). Specifies if sync message signaling
uses kbyte or sbyte or is enabled or disabled.
set-ow Sets the orderwire routing for the network element.
set-state-oc1 Sets the state of OC-1 line(s) to be monitored (IS) for a
good signal or not monitored (NMON).
set-state-ec1 Sets the state of a low-speed EC-1 port to be
automatically monitored (AUTO) for a good signal or
not monitored (NMON).
set-state-t1 Sets the state of a low-speed port to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-state-t3 Sets the state of a DS3 port to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-state-sts1 Sets the state of a STS-1 channel to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-state-vt1 Sets the state of a VT1.5 channel to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-sts1 Sets the signal degrade characteristics of an STS-1
channel.
set-t1 Sets the characteristics of a DS1 port.
set-t3 Sets the characteristics of a DS3 port.
set-vt1 Sets the signal degrade characteristics of a VT1.5
channel.
set-x25 Sets the packet size of X.25 link to either 128 or 256.
3. Determine options required from office records.
To Next Page
Loading...
Need help?
General
