Lucent Technologies DDM-2000 OC-3 User Manual

DLP-523: Detailed Level Procedure 363-206-285
Page 19 of 30 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
Figure 4 – BBG20 TMUX Option Settings
32.
NOTE:
If a signal has previously been applied to the original DS3/TMUX circuit
pack, the FAULT lamp will flash when the new DS3/TMUX is installed
until the signal tests good.
Remove old DS3/TMUX and install replacement DS3/TMUX.
Response: FAULT LED on the DS3/TMUX flashes for about 15
seconds and then goes off.
33. STOP. YOU HAVE COMPLETED THIS PROCEDURE.

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English