DLP-526: Detailed Level Procedure 363-206-285
Page 7 of 8 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
13.
NOTE:
The system prompt may be something other than < if there is an alarm
condition (for example, if there is an MJ alarm condition on the system,
the prompt will be MJ <).
NOTE:
After the prompt (<), the system will respond to commands entered. The
command set-link:pg=( ) maybeusedtosettheverticalsizeofthe
displayed page on the CIT. Page (pg) length may be set from 3 to 150
lines with a default length of 24 lines. The page length is set to default
each time a new CIT session is started.
See the Commands and Reports section of this manual for a description of the
command formats.
14. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General
