363-206-285 Detailed Level Procedure: DLP-532
Issue 2, February 2000 Page 6 of 14
DDM-2000 OC-3 MULTIPLEXER
Letter "P" in FE ID Display
6.
!
CAUTION:
If PC hard drive is being used, ensure you are in the correct directory. If
floppies are being used, ensure the first (number 1) diskette is installed in
floppy drive. Ensure PC is connected to the front CIT (CIT-1) connector.
NOTE:
After the terminal emulator (term) is started, the software download
automatically begins. The download may take 20 to 45 minutes.
Enter term or term COMn command, where n = 1or2.Ifterm is entered
without the COMn option, then COM1 will be selected by default. Disregard
message Can’t find script <init> if you see it after starting the
terminal emulator.
Response: Two brief messages are printed and you are instructed to
Press any key to continue . . . after the
second message. After you press any key, the terminal
emulator is loaded and the terminal responds as follows
within 2 minutes:
CTRM ready. (Type Alt-h for help.)
Communications established.
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress....
The dots continue to print until program installation is
complete. If using floppies, insert each diskette when
prompted. After installation is completed, the PC prints
the following completion message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets and the terminal is logged off the
system.
7. Was response correct?
If YES, then continue with Step 8.
If NO, then proceed to Step 27.
To Next Page
Loading...
Need help?
General
