363-206-285 Detailed Level Procedure: DLP-532
Issue 2, February 2000 Page 8 of 14
DDM-2000 OC-3 MULTIPLEXER
12. Enter the shelf number for the shelf being used for new program download.
Response: PC responds with:
13.
NOTE:
After the system prompt (<), the system will respond normally to
commands entered. The "Commands and Reports" section of Volume 1
of this manual gives a description of the commands.
Use rtrv-ne: command to retrieve the name (tid) of the shelf having new
program installed or see TID in response above. .
14. Enter the command ins-prog:tid or
ins-prog:tid,prmtype=nesw
Where tid = the target identifier (shelf name) for the DDM-2000
shelf having the new program installed.
Where pgmtype = the type of software you want to install.
Response: /*\ Testing For Program Installation...\ */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =.
/*************************************
**
* Lucent Technologies *
* DDM-2000 OC-3 Multiplexer *
**
* Release a.b.c *
**
*************************************/
.
.
.
TID date time
M rtrv-alm:all COMPLD
/* Active Alarms and Status Report
To Next Page
Loading...
Need help?
General
