363-206-285 Detailed Level Procedure: DLP-541
Issue 2, February 2000 Page 5 of 8
DDM-2000 OC-3 MULTIPLEXER
12. Use the rtrv-lgn: command to obtain the Login Provisioning
Report and verify the nonprivileged user logins and user types.
13. See the Commands and Reports section of this manual for descriptions of
related security commands: set-passwd:, rtrv-lgn:, and rtrv-secu:.
14. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
15.
NOTE:
You must be logged into the system as one of the three privileged users
to edit, delete, or enter a user’s login. Initially, the defaults for the
privileged user logins for TARP Release 13.0 or later are LUC01
(uppercase LUC-zero-one), LUC02 (uppercase LUC-zero-two), and
LUC03 (uppercase LUC-zero-three); however, these defaults may have
been changed.
At the login< prompt, enter a valid privileged user login (provided by your
DDM-2000 administrator).
Response: password<
16.
NOTE:
Initially, the default for the privileged user password is DDM-2000;
however, this default may have been changed.
To Next Page
Loading...
Need help?
General
