DLP-561: Detailed Level Procedure 363-206-285
Page 4 of 6 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
Enter term or term COMn command, where n = 1or2.Ifterm is entered
without the COMn option, then COM1 will be selected by default. Disregard
message Can’t find script <init> if you see it after starting the
terminal emulator.
Response: Two brief messages are printed and you are instructed to
Press any key to continue...after the
second message. After you press any key, the terminal
emulator is loaded and the terminal responds as follows
within 2 minutes:
CTRM ready. (Type Alt-h for help.)
Communications established.
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress....
The dots continue to print until program installation is
complete. If using floppies, insert each diskette when
prompted. After installation is completed, the PC prints
the following completion message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets and the terminal is logged off the
system.
6. Was response correct?
If YES, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, then proceed to Step 11.
Letter "d" or "P." in FE ID Display or Display
Blank
7. Ensure PC is connected to the front CIT (CIT-1) connector of shelf receiving
software. If floppies are being used, ensure the first (number 1) diskette is
installed in floppy drive. If hard drive is being used, ensure you are in the
correct directory.
To Next Page
Loading...
Need help?
General
